Kawasaki Ninja ZX Forum banner
1 - 7 of 7 Posts

· Registered
Joined
·
93 Posts
Discussion Starter · #1 ·
I need to remove my swing arm and I am down to ...you guessed it.. that goofy bolt where you need the specialized tool to remove it
anyone know where I can find one of these in the states?

I see them in the UK and they will get here in 2 weeks!!! Trying to avoid the "... grind one of my sockets and build my own..."
Thanks for your help

Todd
 

· Registered
Joined
·
93 Posts
Discussion Starter · #3 ·
You mentioned your two options. Buy and wait or fabricate one out of a socket. Not sure what else to suggest unless you are not worried about damaging it?
All I see is one from the UK ... was just wondering if anyone knew of swingarm sockets for sale in the states. Was hoping to get one here before the 10th of December. ....Just impatient...
BTW... from the measurements it looks like I would have to find a 40mm socket or a steel tube about 2" in diameter just to try to fabricate my own ... UGH !!

Todd
 

· Registered
Joined
·
98 Posts
Nice find!!

Here the description from the Motion Pro site:

Spanner Nut Socket, Kawasaki, 30.5mm / 19.9mm
Equivalent to Kawasaki tool 57001-1450 and 57001-1597
Used for removal and installation of spanner (castle) lock nuts

Large end socket dimensions: 39mm OD x 30.5mm ID x 7mm Pin Width/4 pins

Small end socket dimensions: 26mm OD x 19.9mm ID x 6.5mm Pin Width/4 pins

Part No. 08-0571
$56.99
orders of $29.99 or more ship for free
 
1 - 7 of 7 Posts
Top