Kawasaki Ninja ZX Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter #1
need to know wich zx10r shares the same rod as the zx7r as in the kit item,as iv been told the zx10r rod has the same bearing id's but is a bit longer,as in the same as the kit zx7rr rod,and i just need to have the rod bottom surface ground to the same as the zx7 one as in bottom end width??..it has been done before just need the info.

any help??..need these to run the hi-compression pistons.
 

·
7777
Joined
·
6,664 Posts
You got me going here too. I have a set of 4mm over kit pistons for a 103mm rod, I have been looking for some rods for it. I would have been willing to run a spacer for the longer ZX10R rod (it is 3.75mm longer).

I just checked with Carrillo. On ours, big end is smaller (ZX7R 1.4567 vs. ZX10R 1.4764) and small end is bigger (ZX7R 18mm vs ZX10R 17mm). Not going to work. Bummer.
 
1 - 3 of 3 Posts
Top