Kawasaki Ninja ZX Forum banner

1 - 1 of 1 Posts

·
Premium Member
Joined
·
167 Posts
Discussion Starter · #1 ·
I used a threaded rod and stand off with a hole larger than the bearing . Then I took a washer that would not go into the hole of the bearing , I ground down two sides so it would go in the hole of the bearing . Used the threaded rod and washer to pull out the bearings . It worked fine and I will pull the new bearing back in . Claude thanks for help I needed it . Dan:smile
 
1 - 1 of 1 Posts
Top