Kawasaki Ninja ZX Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter #1
Replaced the battery it was 5 yrs old and was due. Bike ran fine before changing just had trouble starting the last time I rode. Put the new battery in and it turns over fine just won’t start. I’m a little lost. Do these require a fully charged battery to start? I put it on the tender just a minute ago. Is there anything I could have done swapping the battery to cause this?
 

·
Registered
Joined
·
56 Posts
Discussion Starter #2
Figured it out. The wire from the power commander wasn’t grounded. Thanks for the help. I have to say this sight is pretty dead when it comes to helping out a fellow rider. I own a vmax also and they are incredible when I have questions or need help.
 

·
Premium Member
Joined
·
2,141 Posts
Sorry but never had any advise based on the info. Usually if you change something and it won’t start, go back and check everything you did. Never saw a mention of a PC so that would be tough to advise.
Glad you figured it out.
 

·
Registered
Joined
·
56 Posts
Discussion Starter #4
Thanks. Someone must have used a bad connector because I never saw it connected to the negative terminal
 
1 - 4 of 4 Posts
Top