Kawasaki Ninja ZX Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
98 Posts
Discussion Starter · #1 ·
is it normal for the idle needle to be a little shaky? not much just a little bouncy.
 

·
Registered
Joined
·
366 Posts
My first 10 didn't do this, but my current one will idle at 2k for a few minutes and then drop back to 1.5k.
 

·
Registered
Joined
·
98 Posts
Discussion Starter · #4 ·
i mean in the way of the idle not being exactly 1100 rpm. its bouncy a little. like an unsteady finger. its shaky
 

·
Registered
Joined
·
98 Posts
Discussion Starter · #6 ·
i have a full system exhaust and powercomander. would having the full system effect the idle?
when i first start the bike it goes to 1000 rpm and after a few seconds it idles higher untill the bike is warm then goes back down to 1100
 

·
Registered
Joined
·
444 Posts
i have a full system exhaust and powercomander. would having the full system effect the idle?
when i first start the bike it goes to 1000 rpm and after a few seconds it idles higher untill the bike is warm then goes back down to 1100
mine is fully stock exhaust and does the same thing.
 

·
Registered
Joined
·
18 Posts
It's alive!!!!!!

I'd say normal,However if it stops shaking & reads 0 you may need to restart it.(KAWBOY):tard
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top