Kawasaki Ninja ZX Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
118 Posts
Discussion Starter · #1 ·
I bought new gaskets and they are like copper rings. I've never replaced these before and so I am not sure how they work. Is there torque setting? I don't own a torque wrench so trying to see if I can do this. I think I am mechanically inclined however limited to my experiences on motorcycles.
 

·
Registered
Joined
·
224 Posts
well when i dropped mine to repaint i ordered not gaskets.. i believe the manual is to torque the nuts at 14 ft lbs plz some correct me if im wrong.. i also used a little bit of loctit. and when you install the gaskets the flat side goes to the motor and and rounded side touches the pipe
 
1 - 2 of 2 Posts
Top