Kawasaki Ninja ZX Forum banner
1 - 7 of 7 Posts

·
Premium Member
Joined
·
167 Posts
Discussion Starter · #1 ·
I am taking the paint off and will start sanding , polishing it . Then the frame and hang ons . Does anyone have any advice on doing the polishing .I have a big buffer stand up model . I am useing white and grey compound . Thanks Dan
 

·
Premium Member
Joined
·
167 Posts
Discussion Starter · #3 ·
I have the paint off now time to sand . On the side that the hose runs down there is a small grove . This is a long job . Dan
 

·
Registered
Joined
·
161 Posts
Yeah, it is a long process but worth it in the end. Take your time and don't let heat build up in one spot too much. Other than that just wear a mask and make sure anything you want to stay clean is covered up.
 

·
Registered
Joined
·
405 Posts
Wear the crappiest clothes you own ready to be thrown
into the trash can when done. Cloth gloves are a must.
Beer is a must. Any grooves try to smooth out as best
possible without too aggressive a grit. Finish off with Mothers
or 3M polishing compound used for car paint buffer wheels.
Also I used to use Scotch Brite pads for alot of corner work.
 

·
Premium Member
Joined
·
167 Posts
Discussion Starter · #7 ·
I need to know how to remove the needle bearings out of the swing arm . I was thinking of grinding a washer two sides so it will go in and use a rod to drive it out , any help would help . Thanks . Dan
 
1 - 7 of 7 Posts
Top