Kawasaki Ninja ZX Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
FYI
If you have a front hollow wheel axle that takes a large allen to remove/install, the tool that worked for me is the Motion Pro T-6 Hex axle tool it will have a 17mm-19mm-22mm and 24mm. It runs under $30 which is cheaper than getting a craftsman specific Allen. The ZX6R front axle takes 2 differnt sizes of which the tool covers. There are probably other tools that cover the same applications but this one will do the job.
 

·
Registered
Joined
·
604 Posts
Good information there SV996R, i'll keep that in mind, thanks!!!
 

·
Registered
Joined
·
39 Posts
Discussion Starter #3
If you are in a bind you can always go to home depot/Lowes etc and put together a bolt double nut combination to remove install that will run under $5. The only issues are when reinstalling to make sure you achieve the proper torque settings for the axle, pinch bolts and rotor mounting bolts.
 
1 - 3 of 3 Posts
Top