I'm such an idiot. I cleaned up the bike to get her ready for the pictures, and I didn't even take a heads up shot of the kit. Anyway, you ca see it from the side profile. I think it definatly sets her off.
Just got done putting the competition werkes fender eliminator on my ZX6 and can not seem to figure out were $130 worth of equipment is. Other than the price it is a nice kit. It took me about 1 1/2 hours to complete. Ill post pics once the exhaust is back on it. If anyone knows if the RS-5 muffler comes with a power valve or how to over ride it on the bike please let me know. Thanks!!!
Just got done putting the competition werkes fender eliminator on my ZX6 and can not seem to figure out were $130 worth of equipment is. Other than the price it is a nice kit. It took me about 1 1/2 hours to complete. Ill post pics once the exhaust is back on it. If anyone knows if the RS-5 muffler comes with a power valve or how to over ride it on the bike please let me know. Thanks!!!
$110 is pure profit, the cost of finished materials is closer to $20. These people are getting wicked rich. I paid $89 shipped from http://www.fendereliminators.net/ They are selling on ebay at discounted prices. They regualr price is $130 off their website.
All aftermarket mufflers ditch the valve in the exhaust. The mufflers are supplied with the servo limiter so the FI light doesnt come on. Its simple to install the whole setup.
Does anyone have any idea if a 03-04 636 crankshaft fit on a 05-06 636 motor? I know as far as part numbers they are different but when I see pictures of them side by side they look to have same dimensions. I've notices a difference on the end that the reluctor wheel goes on for the crank...
wats up guys! im new to this forum and was hoping i could get some help on my new bike.
i just picked up a 2001 zx600e. i can get it to start with the choke on but the second you give it throttle it dies.
so far i have
-pulled the carbs cleaned them
- new plugs
-synced the carbs
- checked...
Hi guys,
I don’t have a lot of knowledge when it comes to ZX6R’s and even less when it comes to the 6RR. I own a few ZXR 750’s including a 93 homologation model (M1). There’s a 2004 ZX6RR for sale that I’m interested in, mainly because i believe it’s the homologation model. My question is...
Hey everyone, I bought an 05 zx6r and just noticed there aren't any front blinkers. After further investigation, I realized that there isn't a connector for the right blinker. Not sure what the previous owner did. The wiring diagram I found showed the G and B wires for the left and G and W for...
Has anyone experienced this I can ride all the way from fall to the end of spring but when it gets hot ( over 90 degrees) the bike gets to got in town and shuts off can someone offer a direction to look. I've changed the coolant and replaced the water pump seals.
A forum community dedicated to Kawasaki Ninja ZX owners and enthusiasts. Come join the discussion about performance, racing, modifications, troubleshooting, maintenance, and more!
