Kawasaki Ninja ZX Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
320 Posts
Discussion Starter #1
So I'm in need of a new clutch kit and started lookIng. Was wondering what everyone else replaced theirs with. I was looking at the Barnett clutch kit then another question happened. What type friction disk are you guys running too. I'm looking for a good response as to why I should run Kevlar plates over carbon plates. I don't want to buy from the dealer as they want too much money IMO for an oem clutch kit so oem is out the window and can leave oem out of comments lol. So
EBC vs. Barnett vs KG clutch factory
Paper mix crap vs. Kevlar vs. Carbon plates
Lastly what type of plates do not allow full synth oils ( I seen a few say u can't run it)

Will be going to the drag stip every now and again don't ride much city as I live in the country so stiffer springs will prob end up being installed.
 

·
Registered
Joined
·
6,382 Posts
Contact barnett directly.
They've been around a long time for a reason. They should be able to tell you exactly what you should buy.
 
1 - 3 of 3 Posts
Top