Kawasaki Ninja ZX Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hey
I have a 94 ZX 11 that I had the carbs taken apart and cleaned a year ago because of same problem.

Bike starts pretty good, idles fine and doesn't overheat.
As I start to throttle up engine stumbles and dies if I don't let out of it.

Any thoughts?

Thanks
 

·
Banned
Joined
·
3,608 Posts
Check your slide diaphragms. Pull the airbox and blip the throttle and watch to see if the slides come up. You may need to recheck the float level too and see where that goes.
 

·
Senior Member
Joined
·
27,825 Posts
Hey
I have a 94 ZX 11 that I had the carbs taken apart and cleaned a year ago because of same problem.

Bike starts pretty good, idles fine and doesn't overheat.
As I start to throttle up engine stumbles and dies if I don't let out of it.

Any thoughts?

Thanks
Did the bike sit a long time or have you been riding it a lot?
 

·
Banned
Joined
·
3,608 Posts
May need a good cleaning again.
 

·
Registered
Joined
·
9,979 Posts
That or the bike has been modified, like the 'float-bowl [vent] mod' and something wasn't done or reconnected properly.
 
1 - 7 of 7 Posts
Top