Kawasaki Ninja ZX Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello!

I just put the engine back in the bike after having the starter clutch replaced. All seemed fine until I was testing the clutch. It will not disengage.
The clutch was fine before having the starter repaired.
I have checked the master and slave cylinder and bleed the line several times. It still will not disengage. If I put it gear, hold the clutch in and rock the bike back and forth it feels like the plates loosen up and it rolls, however it does feel like it is dragging a bit. Now if I let go of the clutch and re apply the clutch, it's back to not disengaging until I rock it back and forth again.

Any help would be great ! I'd like to get in a few more rides this season.

Thanks
-- Brian
 
1 - 1 of 1 Posts
Top