Kawasaki Ninja ZX Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
So a silly question but i have to ask it .
Brembo brakes upgrade to my gen 3 , would it be that much of a difference to hard braking on the track.
I have the OEM setup at the moment but have put a good set of braided hoses on which made a big difference , if i put brembo pads in would this be worth it or should i just upgrade the lot
Archy
 

·
Registered
Joined
·
713 Posts
I upgraded my calipers, rotors, brake lines, and master cylinder on my Gen 1. HUGE difference
 

·
Registered
Joined
·
16 Posts
Discussion Starter #4
hey , thanks for the reply , i thought i wasnt getting my posts viewed . I am bidding on some Brembo monoblock calipers now. Havent heard of your calipers though are they monoblock calipers ?
 

·
Registered
Joined
·
16 Posts
Discussion Starter #5
I looked up your upgrade they are roughly the same price as Brembo , you recommend them iam guessing lol
 

·
Registered
Joined
·
713 Posts
They are just as good as Brembo monos but for the price of Brembo 2 piece cast.

The bike stops with one finger now.
 

·
Registered
Joined
·
16 Posts
Discussion Starter #8
Hey , thanks for reply . I am considering them now as I upgrade.
Do you think it's not worth upgrading unless I change the master cylinder too . A few people said it's a big improvement but the upgrade cylinder needs to fitted too
Archy
 

·
Registered
Joined
·
713 Posts
You have a radial m/c, it will work good with new calipers and ss lines.

Mine (Gen 1) was not a radial m/c and it was horrible.
 

·
Registered
Joined
·
713 Posts
Accossato also makes the m/c and is cheaper than the Brembo. I only used the Brembo RCS because it was a spare I had in my parts bin.
 
1 - 14 of 14 Posts
Top