|Topic Review (Newest First)|
|05-13-2009 11:32 AM|
|doc762399||So then what do you rejet your carbs to? Needle size? jet size????|
|05-13-2009 11:06 AM|
the kleen mod and floatbowl mod are done at the same time...with your reed valves being blocked off, the emissions arent working as it is. so, youre halfway there.
heres the site youre looking for
|05-13-2009 09:55 AM|
Originally Posted by villian88 View Post
|05-13-2009 12:28 AM|
Float Bowl Mod/KLEEN Mod - HELP!
Ok you guys, I'm confused again. I've got my bike down to the carbs, so figured I should do this mod...since it hasn't been done before. Only questions are:
1. My bike is jetted, has a Flo-Commander, Full Muzzy Stainless Steel Exhaust, and seems to run fine...and not run overly lean/rich. In this case, should I still consider doing the Float Bowl mod, or is there really no benefit other than to keep your bike from running lean...which mine apparently doesn't do?
2. The KLEEN mod...does it only apply to California model bikes? Mine doesn't have that whole clean-air valve thing, instead I simply have a hose going from one Reed plate to the other. We're they like this from the factory, or has someone already done the mod?
3. Float Bowl Mod - Anyone on here actually have a good write up, or some decent pictures. The normal writeups I've found (that everyone points you too) absolutely suck, they have pictures, and text, but with no overlaying directions...they're simply pictures with directions written above and/or below...which is fine....unless you have no clue what each part in each picture is called. Then you're royally screwed.