ZX Forums - View Single Post - correct firing order with wire correction
View Single Post
post #10 of (permalink) Old 07-20-2011, 08:57 PM
kawa kid
Senior Member
 
kawa kid's Avatar
 
Joined: Apr 2008
From: Pacific Northwest

Posts: 454
Switching the high tension leads between 2/3 or 1/4 wont make a difference if they attached to the correct coil. Have you done any engine work such as cam timing? If not, do you have a bad valve in #3? You can verify the valve by a compression check.
Just a couple of thoughts.

Kawa kid
kawa kid is offline  
 
 
For the best viewing experience please update your browser to Google Chrome