Any engine builders?

[1Fast7]

I need to know the location of the crank shat when it is TDC.

[ninja11zx]

timing plate is on the right hand side of the motor.

[1Fast7]

I need to know what angle/degree the crankshaft is at when cylinder 1 is top dead center. The kawasaki manual dose not say it only give specs and run outs.

[ninja11zx]

#1 and #4 rod journals are straight up. timing plate will line up 1 and 4 position with a mark on the cases.

[1Fast7]

What i'm looking for is in example when cylinder 1 is top dead center the crankshaft is at 120 degrees. I know where the marks line up i need the angle/degree of it. What i have to do is make a new ignition wheel with 24 teeth evenly spaced then grind one of so that i have a skipped tooth. I need this to program the ecu for the fuel injection that i have done.

[suprajztwenty]

niiiiiice idea dude, what fi system are you piecing together? sorry i dont have an answer, but im really curious how its gonna turn out.

[1Fast7]

The throttle bodies are from a 636 the bore spacing is the same so they don't need respacing. You also have to use the manifolds from zx6/636 also.