Lockhart Phillips LED Tail light w/ intagrated signals
I was wondering if anyone was familiar with this tail light, i recently purchased it for my 08, installation was a breeze until it came to the LED signals, there is only one wire for each signal and the stock wiring harness has that plastic plug with 2 terminals (+/-)... i wasn't given a schematic, so i'm a bit confused as to how they connect... was wondering if anyone has used this tail light and can aide in my dilemma before i go apeshit on the manufacturer... i'd appreciate any feed back
__________________
Slip it and Rip it.... Waaa Waaa
07 ZX-6R (gone)
08 ZX-10R (TOTALED)
08 ZX-10R (Lime) New GF!
its normal LOl you only need to connect the positive wire from your stock wires to the wires seperate, left stock wire (positive) to the left wire from the new light then put in your resistors to slow the blink rate down and connect your negative stock wire, to the other end of the resistor, same thing for the other side, if this dont make sense just let me know LOL
__________________
"Always cover your rear break"
"its a Thousand dude!"
its pretty simple just try stuff out. if its not right then it wont light up if you got the wires swapped the right blinker will flash when turning left. just plug and test but to what lyodbraun said. google is also an amazing tool if you try it.
was wondering if anyone has used this tail light and can aide in my dilemma before i go apeshit on the manufacturer... i'd appreciate any feed back
to what lyodbraun said. google is also an amazing tool if you try it.
