|
Okay, I have also joined the club. The flys came out today and WOW! what a difference. My engine is noticablly smoother and the seat of pants experience is awsome. This bike pulls alot harder now and the reponse is very crisp. I'm running a PCIII with map provided by Dynojet.
I can now offer some advice when removing your flys. Definetly use a propane torch to heat up the screwdriver. I started by using a soldering iron and almost stripped the screws. Using a torch to heat the screwdriver made it alot easier. Just hold the screwdriver on the screw for about 20 seconds before turning. Make sure you are using a good #2 screwdriver. Rounded ones can easily give you grief.
Good bye for now. I'm going riding.
Last edited by Az-ZX-14 : 06-29-2008 at 04:30 PM.
Reason: spelling
|
