Quote:
Originally Posted by BlueBomber14
 to Flyer i also think it was a way for Kawi to prebuild some future mods into the bike to make it easier for them to update the next years model without doing a lot of extra work.
I would recomend going one step further than just running the bike to warm up the loctite you need to heat up the tip of the screwdriver and hold it on the screws for a solid 30 seconds before attempting to loosen them 
Lowcells link above is dead here is a local link on this forum for ya to Gander at hope it helps.
http://www.zxforums.com/forums/zx-14...ht=butterflies |
Thanks for adding the additional information and the link. I warmed my bike up and then used a soldering iron on the screws. I did end up having a problem with the forth screw from the left. All the rest came out relatively easy, that one took me over an hour to drill out.
