|
carb setup
Have the same bike and pipe and filter,only difference is stick coil conversion,but i have a factorypro jet kit installed,after reading many post's and set up guide's i set the needles at pos.2 with shim under,mains 162 out,160 in,float height 15mm and mixture screws 2 1/4 out,runs great with no flatspot at 3500 rpm,takes full throttle in top from 1500rpm with no dips in power i can feel,am going to put it on the dyno next week to get a printout and see the difference from before with standard jetting,will post graph's
|
